*THIS LISTING IS FOR 3D PRINTING FILES ONLY*
 
I made this to hold my trading cards for ease of access while in kit. It has an integrated belt loop and a removable top that can be installed with either small velcro strips between contact points or magnets epoxied to the Box and top plate. The spring plate will need two springs that fit the groove inside the box and it is recommended you epoxy one side of the spring to the spring plate. This keeps pressure on the cards pushing forward. A small curve ramp is modeled into the bottom of the front side that allows cards to naturally want to move up towards the opening. A slit is cut to allow for cards to be drawn up by finger through the exposed face on the front of the box. Fielded this and tested at a con to good results. Results vary depending on the strength of the spring installed.
 
Trading card max dimensions: 2.5" x 3.5"
 
Please do not share files without explicit consent of Warlord Arsenal. They are for personal use only, no one is allowed to sell physical 3D prints of these or make casts of these. Thank you.