*THIS LISTING IS FOR 3D PRINTING FILES ONLY*
 
Thank you for purchasing 'The Convergent Series: Jetpack' design by Warlord Arsenal!
 
A fully customizable Jetpack design inspired by the designs seen on the TV series - there are multiple rocket & trim options to tailor this to your own custom needs. The backside of the jetpack has 4 access plates that can be removed if installing any electronics or fogger's inside the jetpack itself. The jetpack can be printed whole if your print bed is large enough, but there is also split versions to allow for smaller beds. Trim pieces and Rockets are all installed by dowels. See below for the dowel sizes needed:
 
1" [Rockets, Side Trim Tops/Bottoms, Boosters]
.25" [Small Trim On Shelf]
 
It is possible to install pins inside into the 1" dowels for the tops/bottoms/boosters in order to make them removable if needed. The center hole for the Rocket has a predrilled hole for a screw so that these can be readily removed/changed/swapped for storage purposes or to change the look of the jetpack. Customization is key!!
 
Thank you for viewing!
 
Please do not share files without explicit consent of Warlord Arsenal. They are for personal use only, no one is allowed to sell physical 3D prints of these or make casts of these. Thank you.